Skip to content

Did you know?

You can make us an offer.

The price on the page is not the only way to buy. Tell us what you would like to pay and the studio will reply by email.

  1. 1Choose your piece, metal and diamond.
  2. 2Tell us the price you have in mind.
  3. 3The studio reviews it and replies by email.

Up to 3 offers per piece. No payment details needed to send one.

Carat, size and price · Guide

Diamond Length to Width Ratio Guide by Shape

Length-to-width ratio sets a diamond's outline. A classic oval is about 1.35 to 1.50, a pear 1.50 to 1.70 and a marquise 1.85 to 2.10. Ratios by shape.

By Steven V., Master Jeweler, 20+ YearsUpdated 2 min read

Diamond Length to Width Ratio Guide by Shape
In this guide

Quick answer

A diamond's length-to-width ratio is its length divided by its width, and it decides whether a shape looks slim or full. There is no single correct ratio; these ranges give the classic look for each shape:

Shape Classic ratio
Oval 1.35–1.50
Pear 1.50–1.70
Marquise 1.85–2.10
Emerald 1.35–1.50
Radiant (rectangular) 1.20–1.35
Cushion 1.00–1.05 square, 1.10–1.25 elongated
Princess, Asscher 1.00–1.05
Heart 0.95–1.05

How to calculate the ratio

Take the measurements from the grading report, which list length × width × depth in millimeters. Divide the first number by the second. A stone measuring 8.10 × 5.70 × 3.50 mm has a ratio of 8.10 ÷ 5.70 = 1.42. For a heart, the measurement is taken from the top of the lobes to the point, and width across the widest part, so a heart near 1.00 looks balanced.

Round diamonds should be as close to 1.00 as possible. A round measuring 6.40 × 6.45 mm (1.01) is fine; anything noticeably above that is slightly out of round.

How ratio changes the look on the hand

  • Higher ratio: a longer, slimmer stone. It lengthens the finger and tends to look larger for its weight because more of the outline runs along the hand.
  • Lower ratio: a wider, fuller stone. It reads as softer and more classic, and on ovals and pears it is closer to round.

Personal taste matters more than any chart. A 1.30 oval suits someone who likes a fuller look; a 1.55 oval suits someone who wants a dramatic, elongated stone.

Shape by shape notes

Oval

Below about 1.30 an oval starts to look like a stretched round. Above 1.55 it becomes very slender. Ovals can show a bow tie, a dark band across the center, which tends to be stronger in higher ratios; see the bow tie guide. More in our oval diamond guide.

Pear and marquise

A pear under 1.45 looks short and round-shouldered; over 1.75 it looks narrow. Marquise stones are naturally long; under 1.75 they look stubby. Check that the point is centered and the two halves match.

Cushion and radiant

Both come square or elongated. An elongated cushion is softer, with rounded corners; a rectangular radiant has cropped corners and crisper sparkle. Compare them in elongated cushion vs radiant cut.

Emerald, princess and Asscher

Emerald cuts are rectangles; 1.35–1.50 gives the classic proportion. Princess and Asscher cuts should look square, ideally 1.00–1.05, because a stretched square looks like a mistake rather than a style.

Ratio mistakes to avoid

  • Choosing only from photos. Ask for the report measurements and calculate it yourself.
  • Ignoring the setting. Prongs and halos change the outline slightly, especially on small stones.
  • Forgetting the hand. Long fingers carry high ratios well; shorter fingers often look best with a moderate ratio.

Diamond Studio center diamonds come in ten shapes, and at the same carat and grade every shape is the same price. Explore them on our engagement rings.

Frequently asked questions

What is the best ratio for an oval diamond?

The classic range is 1.35 to 1.50. Lower looks fuller and closer to round; higher looks slimmer and more dramatic. Choose the one that suits the hand.

Does the ratio affect price?

Usually only a little. Very popular ratios can be in higher demand, but carat, color, clarity and cut have far more effect on price.

Can a round diamond have a ratio above 1.00?

Yes, slightly. Most well-cut rounds measure 1.00 to 1.01. A higher ratio means the stone is a little out of round, which can be visible in a solitaire.

Which ratio makes a diamond look biggest?

Elongated stones with higher ratios cover more of the finger's length, so they tend to look larger per carat. A 1.50 oval often looks bigger than a 1.30 oval of the same weight.

Put it into practice

Engagement rings to start from

Every design in any shape, metal and carat, with an IGI-certified lab-grown or GIA-certified natural diamond.

Shop engagement rings

Certification

Certified, every piece

Engagement rings come with an IGI or GIA certificate, and every other piece with a Diamond Studio certificate of authenticity.

Still deciding? Ask the people who make it.

Amit, Shimi and Steven V. answer questions from our Fifth Avenue studio, by message or on a call.

Or follow along

Your bag (0)

Your bag is empty.

Start with a ring, then add the matching band and earrings.

Explore engagement rings