In this article
Quick answer
No. A lab-grown diamond does not cloud, fade or turn yellow with age. It is the same carbon crystal as a mined diamond, with the same hardness of 10 on the Mohs scale, and its structure does not change in normal wear. When a diamond looks cloudy, the cause is almost always one of these:
- A film of skin oil, lotion or soap on the surface (the most common cause).
- Haze from inclusions or graining that was in the stone when it was cut.
- A simulant such as cubic zirconia, which can look cloudy as it wears.
Why the myth exists
The idea that lab-grown diamonds turn cloudy usually comes from confusion with simulants. Cubic zirconia is softer than diamond, so its surface collects fine scratches and a film that make it look milky over the years. A lab-grown diamond is not a simulant. It is a real diamond, with the same crystal structure and refractive index of 2.42 as a mined one, so it ages the same way: it does not. Our cubic zirconia vs diamond guide shows the differences side by side.
What actually makes a diamond look dull
Surface film
Diamonds attract oil. Hand cream, soap, sunscreen and the natural oils on skin build up on the underside of the stone, where light enters and reflects. Even a thin layer can make a bright diamond look flat and grey. This is fully reversible with cleaning.
Haze that was there from the start
Some diamonds, natural and lab-grown alike, contain clouds of tiny pinpoint inclusions or internal graining. In lower clarity grades this can give a faint haze. It does not get worse over time, but it also does not go away, which is why it should be checked before you buy. Certain lab-grown stones can also look slightly grey or brown because of growth strain; our article on why some lab-grown diamonds look grey or milky explains how to spot it.
Damage
Diamond is very hard but not unbreakable. A sharp knock can chip an edge, and a chip can look like a cloudy spot. This is damage, not ageing.
How to keep a diamond bright
- Soak the piece in warm water with a few drops of mild dish soap for 15 to 20 minutes.
- Brush gently with a soft toothbrush, especially behind the stone.
- Rinse under running water (with the sink plugged) and dry with a lint-free cloth.
- Put rings on after lotion and take them off for cleaning, gardening and the gym.
For settings with pavé or many small stones, see our jewelry care guide before using an ultrasonic cleaner.
How Diamond Studio covers this
Our lab-grown diamonds carry a lifetime warranty against cracking, damage and clouding while they are in your possession, and the warranty also covers lost or loose melee and accent diamonds. Engagement ring center diamonds are offered in VS1, VVS2 and VVS1 clarity, grades where inclusions are very hard to see without magnification. The full terms are in our return policy and warranty, and you can browse engagement rings with lab-grown or natural centers.
Frequently asked questions
Do lab-grown diamonds change color over time?
No. A lab-grown diamond keeps its color for life under normal wear. Its color is set by its crystal structure and trace elements, which do not change from sunlight, water or daily use.
How can I tell if my diamond is cloudy or just dirty?
Clean it properly with warm soapy water and a soft brush, then dry it. If it sparkles again, it was dirt. If a haze remains, ask a jeweler to look at it under magnification.
Does moissanite get cloudy like cubic zirconia?
No. Moissanite is much harder than cubic zirconia, at 9.25 on the Mohs scale, so it resists the surface wear that makes cubic zirconia look milky. It can still collect oil and dirt.
Can a cloudy diamond be fixed?
Surface dirt can always be cleaned off. Internal haze from inclusions cannot be removed, and a chipped stone may need to be repolished or replaced, depending on the damage.



